Skip to Content

How To Fix Glitter Tumbler Mistakes

Let’s admit that making mistakes on your glitter tumbler is just not fun.

You love making resin art because it allows you to make stunning crafts for yourself or your friends and family. I bet you’ve seen lots of DIY tumblers that you’d love to make or maybe even tried making already.

But if you’re new to the art, you may run into some trouble fixing your tumbler.

So what do you do when that happens? Let’s delve into more detail below.

I get commissions for purchases made through some of the links in this post. There is no extra cost to you. See my full disclosure here.

Short on time? Pin this post to your crafts board on Pinterest for later.

Common glitter tumbler mistakes

Here are some common errors.

  • Proportions are important when mixing the resin. If you get it wrong, your epoxy will be too hard or runny, which can cause bumps or waves on your tumblers.
  • There are different types of resin available. If you use the wrong one for your tumbler, it affects how the glitter work looks. 
  • If it’s too hot or too cold, your glittery layer won’t set properly, which may cause it to run off. 
  • If the tumbler or your hands are too oily, it could also affect how the resin sets on the tumbler. It won’t stick well on the oily patches making your final work bumpy. 

Once you’ve figured out where the problem may be, it’s time to correct and bring your work up to the standard you want. 

ice resin clear epoxy resin

Tip 1: Fix uneven glitter work by mixing and adding some new resin

If your glitter finish is uneven, you can add another layer of new resin (discard the old one). 

Use approximately a quarter of the amount you initially used or just enough to cover the whole surface of the tumbler. Simply pour the new wax on top and ensure it’s even throughout.

If the resin has already dried, you’ll need to sand it down before adding the next layer. 

Remember to ensure that: 

rainbow glitter how to fix errors on diy tumblers

Tip 2: Get rid of bumps and ripples by adding more layers of epoxy resin

If your resin is curing well but looks wavy, you can keep adding more layers of the same glitter layer that you’ve already mixed. Work in thinner layers until you get a smooth exterior. 

Ripples are usually a sign that your working surface is bumpy, so you don’t need new resin. Just keep adding more layers until it smoothes out. 

You may also have to wait for a warmer day to craft since cold weather thickens the resin hence the air bubbles. 

This mini dryer also helps to get rid of bubbles, so you can try using that regardless of the weather.

Tip 3: If the resin won’t dry or is too sticky, restart the project

If your glitter tumbler outer layer just won’t dry no matter how much time you give it, it’s best to scrape off the resin and start over. 

Make sure you clean the tumbler thoroughly and let it dry. Then mix a new epoxy and start over. 

You can get it right this time by ensuring that you:

  • Check that the type of resin is compatible with the hardener. Some brands of epoxy don’t work with hardeners that have polyester catalysts. 
  • Wait for a warmer day. Extreme cold can affect the resin mixture preventing it from curing properly. 

So there it is, now you’re ready to take on any glitter tumbler resin project without mistakes. Go ahead and enjoy your craft.